RF Wireless Remote Dimmer

Model # NT101B / NT101A

NT101B/ NT101A RF Wireless Remote Dimmer is perfect for operating your single-color LED light strips. The LED remote uses brightness +/- controls or 6 button shortcuts to dim light strips from 10%-100%, and it controls your light strip from greater than 50′ away in open air. The dimmer is compatible with LED light strips that operate within a 5-24V DC range.

  • Remote
  • Receiver
Model No.NT101B / NT101A
Work VoltageDC 5-24V
Output1ch X 5A
Brightness Grade64 Levels
Direct Color Select6 Direct Keys
PWM Grade256 Steps
Overload ProtectionYes
Overheat Protection Yes
Remote Frequency433.92 Mhz
Remote Controller Distance> 15m at open area
Remote Dimension85 X 40 X 5 mm
Controller Dimension46 X 13 X 6 mm
Battery 3V CR2025
IP RatingIP 20

Operating Manual

  • 1. Turn On/ Standby
    Press to turn on unit or switch to standby mode. At power on, unit will automati-cally turn on and restore to previous setting
  • 2. Brightness Adjust
    Press BRIGHT(+) to increase brightness and press BRIGHT(-) to decrease brightness.
  • 3. Brightness Shortcut
    Directly switch to 100%, 80%, 60%, 40%, 20% or 10% of full brightness.
  • 4. Power Supply Wiring
    The main unit can work at DC 5V to 24V power supply. The red cable (or inner pole of DC jack) should be connected to positive and black cable (or outer pole of DC jack) to negative. Make sure the power supply voltage matches the LED strip requirement, incorrect voltage may damage strip.
  • 5. LED Output Wiring
    The red cable (or inner pole of DC plug) should be connected to LED positive and black cable (or sleeve pole of DC plug) to negative. Use LC2 male connector on controller to plug in female LC2 connector on LED strip.
    The peak output current is 12 amperes and maximum constant current is 6 amperes, please reduce load if main unit is over heating.
    CAUTION! Do not short circuit or overload the LED outputs, this may lead to permanent damage!
  • 6. Using Remote Controller
    Please pull out the battery insulate tape before using. The RF wireless remote signal can pass through barrier, so it's not necessary to aim at the main unit when operate. For proper receiving remote signal, please do not install the main unit in closed metal parts.
  • 7. Pairing a new remote
    up to 3 wireless remotes can be assigned to operate the LED controller. Additionally, each individual wireless remote can be assigned to an unlimited number of controllers. The following steps show how to assign a new remote to the LED Controller:
    1) Disconnect the power to the LED controller, wait 5 seconds, and reconnect.
    2) Within 5 seconds of reconnecting the LED Controller, press the '100%' and '60%' buttons simultaneously.
    After this operation, the main unit will recognize the new remote controller.
  • 8. Free Remote Paring Mode
    Up to 3 wireless remotes can be assigned to operate the LED controller. The following steps show how to assign a new remote to the LED controller:
    1) Disconnect the power to the LED controller, wait 5 seconds, and reconnect.
    2) Within 5 seconds of reconnecting the LED Controller, press the 'ON/OFF' and 'BRIGHT+' buttons simultaneously.
    After this operation, the main unit will recognize any remote controller. To pair the main unit back to speccific remote, please repeat the ‘Paring New Remote’ operation.
.